| |
|
QuiltCut2
Cutting Squares
|
1. |
|
With strips in place on the Cutting Mat and with
edges touching, move the Cutting Guide to the Clamp Bar rail. Leave the Cutting
Guide angle at 90° for cutting squares or rectangles. Make sure there is
no space between the strips of fabric. Be sure the Clamp Bar is lowered. |
|
2. |
|
Align the edge of the Cutting Guide at the ends of the strips
to make an even first cut. Cut off and remove the selvage edges. |
|
3. |
|
If necessary, set the Speed Gauge for the correct measurement.
Slide the Cutting Guide so the inside edge of the Speed Gauge is at the cut you
made in step 2 and make the next cut. Take care to lift the Cutting Guide off
the Mat as you slide it so it does not disturb the fabric. If you are going to
be cutting triangles do not remove the squares or rectangles yet. Repeat by lifting
and sliding the Cutting Guide, aligning the inside edge of the Speed Gauge on
the cut you just made and cutting until you have the number of pieces you need.
|
|
4. |
|
Use QuiltCut2 to selectively cut, square up or trim individual
pieces. |
|
|
| |
